# 3D model and schematic cross-probing

> See the board in 3D from an uploaded STEP model, and cross-probe between the schematic (intent) and the layout (as-built).

_Source: E-Sharp (esharp.se) · Probe guide_


Two views help you read the design the way a human does: the 3D model and cross-probing against the schematic.

## The 3D model

A 3D model (from an uploaded STEP) lets you see the board as it's built — heights, mechanical fit, where things sit. It complements the layer view when a question is physical rather than electrical.

## Schematic cross-probing

Probe reads the schematic as **intent** (via vision, sheet by sheet), while the netlist is the as-built truth. Cross-probing lets you jump between a part in the schematic and the same part in the layout — so "what did the designer mean" and "what was built" can be set against each other.

## Why both

The netlist says *what* is connected; the schematic says *what was intended*. A finding often arises in the gap between them — and that's why Probe holds both, rather than trusting one.

---

Related: [the viewer — a tour](/en/probe/support/the-viewer-a-tour) and [what Probe finds](/en/probe/what-probe-finds).

*Probe is E-Sharp's design-review engine. The schematic is read as intent, the netlist as as-built.*
