# The viewer — a tour

> A walkthrough of the Probe viewer: board picker, stackup layers and overlay, locate a component, net highlight and ratsnest, click-to-identify and coordinate readout.

_Source: E-Sharp (esharp.se) · Probe guide_


The web viewer is where you see the board and the findings. Probe itself doesn't reason in the viewer — it presents the as-built connectivity and the cited findings the review produced. Here are the parts you use most.

## Board picker and layers

Pick board and take at the top. The **stackup layers** can be turned on and off and placed in overlay — copper, mask, paste, silk, drill — in the board's own millimetre coordinate system (X right, Y up). That's how questions no netlist can answer get answered: is a fiducial clear, do two designators collide, does silk run over a pad.

## Locate and cross-probe

- **Locate component** — find a reference designator on the board.
- **Net highlight + ratsnest** — mark a net and see its connections.
- **Component ↔ net cross-probing** — jump between a part and the nets it sits on.
- **Click to identify** — click on the board and find out what's there.

## Findings and readout

The design-rule findings are shown in the viewer, pinned at net, layer or component. Coordinate readout and performance counters are there for anyone who wants to measure and troubleshoot.

---

Related: [read and export findings](/en/probe/support/read-and-export-findings). Deep dives: [power and PDN](/en/probe/support/power-and-pdn), [signal integrity](/en/probe/support/signal-integrity), [stackup and copper](/en/probe/support/stackup-and-copper).

*Probe is E-Sharp's design-review engine. The viewer shows the as-built — the AI in your tool does the reasoning.*
