Boards, takes and the design line

How a design enters Probe as a take on a design line, when a take is complete, and what carries over to the next take.

View as Markdown (for AI/KB) Whole knowledge base (llms.txt)

A design enters Probe as a take on a design line. Understanding those words is the basis for everything else: it decides what Probe reviews, what counts as “the same board” and what carries forward when you upload a new version.

Design line, revision and take

A design line is the board over time — the same design through its revisions. A take is a single upload on that line: a specific input at a specific moment. A revision bump or a new export becomes a new take that supersedes the previous one in the chain.

Two takes of the same design are different boards to Probe. That’s deliberate: a report that doesn’t name which take it applies to can land on the wrong version. That’s why everything Probe prints carries a source line with board and take.

When a take is complete

A take becomes visible only when it is complete — a half-ingested take would inflate confidence in evidence that isn’t there, so it’s hidden until the last piece arrives.

  • Before layout: schematic + BOM + netlist.
  • After layout: schematic + BOM + ODB++.

So you can start reviewing before the layout exists. If you upload an ODB++ before its schematic and BOM, the take is incomplete and doesn’t appear in the interface until what’s missing arrives.

What does not carry over to the next take

The artefacts aren’t inherited. Each take stands on its own input: schematic, BOM, ODB++, 3D model and fab package belong to that take and aren’t carried over. That’s by design — a new take should be reviewed against what it actually carries, not against a previous version’s files.

What does carry over

When the underlying material is unchanged, review decisions, facts and observations carry over to the new take. So you don’t start from scratch at every revision — what’s already settled and still applies is carried forward, while what changed is opened for new review.

What you may need to state again is things that belong to the individual take’s artefacts (e.g. a layer mapping for a new fab package).

Correct a name without a new take

A misspelled product or design-line name is corrected across the whole line without creating a new take — the name is a property of the line, not of an individual upload.


Next step: Run your first review, and read about the driven review for how the pass itself is driven card by card.

Probe is E-Sharp’s design-review engine. Probe doesn’t reason on its own — the AI in your own tool does the reasoning and you make the technical call.

Book a demo of Probe

Show us your board — we review it and go through the findings together.

Prefer to email? info@esharp.se