Review before layout

What you can review with schematic, BOM and netlist before the layout exists — and how the pre-layout take becomes an ODB++ take on the same design line.

View as Markdown (for AI/KB) Whole knowledge base (llms.txt)

You don’t have to wait for the layout to start reviewing. With the right material, Probe runs a meaningful review at schematic level already.

What’s required

A pre-layout take needs schematic + BOM + netlist. Then you have the connectivity (what’s connected to what), the component identity (reference designators, packages) and the design intent via the schematic.

What can be checked — and what waits

Checks that build on connectivity and device behaviour can run already: domain and voltage reasoning, open-drain in a chain, a missing pull-up, drive conflicts. Checks that need physical geometry — stackup, impedance, IR-drop, creepage — wait for the layout and run once an ODB++ arrives.

From pre-layout to ODB++

When the layout is done you upload the ODB++ export as the next take on the same design line. What’s already been worked out and still applies carries forward (see boards, takes and the design line), so the pre-layout work isn’t wasted.


Next step: upload an ODB++ design.

Probe is E-Sharp’s design-review engine. A rule without enough data abstains rather than passes.

Book a demo of Probe

Show us your board — we review it and go through the findings together.

Prefer to email? info@esharp.se